Festo CP-FB13-E - Table of Contents

To Next Page

To Previous Page

Contents and general instructions

III

Festo P.BE-CP-FB13-E-EN en 0112e

Contents

Intended use V..........................................................

Target group V..........................................................

Service VI...............................................................

Notesontheuseofthismanual VI...........................................

Important user instructions VII..............................................

1. Installation 1-1...................................................

1.1 General instructions 1-3.............................................

1.2 Setting with the DIL switch 1-4.......................................

1.2.1 Setting the field bus address 1-7......................................

1.3 Field bus baud rate and field bus length 1-10............................

1.4 Connecting the CP modules 1-12.......................................

1.5 Connecting the power supply 1-13.....................................

1.6 Connecting the PROFIBUS-DP interface 1-14.............................

1.6.1 Screening connection 1-15............................................

1.6.2 Bus termination with terminating resistors 1-17..........................

1.6.3 Optical-fibre waveguide connection 1-19................................

2. Commissioning 2-1................................................

2.1 Preparing the CP system for operation on the PROFIBUS-DP 2-3............

2.1.1 Power supply 2-3..................................................

2.1.2 Saving the string assignment 2-3.....................................

2.1.3 Compiling the configuration list 2-4...................................

2.1.4 General information 2-5.............................................

2.2 Configuration with a Siemens master 2-13...............................

2.2.1 Preparations for COM PROFIBUS 3.x and 5.0 2-13.........................

2.2.2 COM PROFIBUS 3.x 2-15.............................................

2.2.3 COM PROFIBUS 5.0 2-19.............................................

2.2.4 Configuration examples for COM PROFIBUS 3.x and 5.0 2-22................

2.2.5 Input and output addresses with COM PROFIBUS 3.x and 5.0 2-23...........

2.2.6 STEP7 5.1 - Hardware configurator 2-24.................................

2.2.7 Addressing examples 2-30............................................

Other manuals for Festo CP-FB13-E