Contents and general instructions
V
Festo P.BE-CP-FB13-E-EN en 0112e
Intended use
The CP field bus node CP-FB13-E described in this docu-
mentation is intended exclusively for use as a slave on the
PROFI BUS-DP. CP modules from Festo can be connected to
the CP field bus node CP-FB13-E. The CP node may only be
used as follows:
–asintended
– in original condition
– without any modifications
– in faultless technical condition
In conjunction with additional commercially available compo-
nents, such as sensors and actuators, the specified limits for
pressures, temperatures, electrical data, torques etc. must be
observed.
Please observe the standards specified in the relevant
chapters and comply with national and laws and regulations.
Warning
If to be used as an explosion-protected operating device,
make sure that:
S electrical contacts are not disconnected under tension
S the completely fitted product with all plugs, adapters
and protective caps complies at least with protection
class IP 64.
Target group
This manual is directed exclusively at personnel trained in
control and automation technology, who have experience in
installing, commissioning, programming and diagnosing
slaves on the PROFIBUS-DP.
To Next Page
Loading...
