Festo CP-FB13-E - Operation with the General DP Master

2. Commissioning
2-35
Festo P.BE-CP-FB13-E-EN en 0112e
Recommendation:
Providing the safety concept of your machine/system per-
mits, commission the CP system with both operating voltages
(pins 1 and 2), but without compressed air . Y ou therefore
have a suitable test function which does not trigger undesired
reactions.
Please note
A CP valve location occupies two addresses. The following
applies:
– lower-value address: pilot solenoid 14
– higher-value address: pilot solenoid 12