2. Commissioning
2−13
Festo P.BE−CPX−FB11−EN en 0503b
Example 3: CPX terminal with analogue module and
CPApneumatics
The address assignments for this CPX terminal are shown in
the next page in Tab.2/9. The settings are:
Status bits activated and I/O diagnostic interface
deactivated
Pneumatic interface set with DIL
switch to 1...8 valve coils
(8DO).
1
2
8DI 8DI 4DO 8DI 2AO
3
8DO
8 O
Module no.: 01 2 3 4 5 6
1 Field bus node CPX−FB11
(with DIL 3.2 to ON for status bits)
2 Pneumatic interface
(set with DIL switch to 1...8 valve coils)
3 CPA pneumatics
Fig.2/3: Example terminal 3 (with analogue module and CPA pneumatics)
To Next Page
