Festo CPX-FB11 - Parameterisation Methods

2. Commissioning
2−41
Festo P.BE−CPX−FB11−EN en 0503b
2.3 Parameterisation
Caution
A different parameterisation will result in a different reac
tion. Check especially when replacing CPX terminals to see
which settings are necessary and make sure that these
settings, where applicable, are carried out (e.g. in the
start−up phase by the higher−order PLC/IPC).
The CPX terminal is supplied with preset parameters.
The system reaction of the CPX terminal can usually be
adapted to the relevant application. You can set the reaction
of the CPX terminal as well as the reaction of individual mod
ules and channels by parameterisation. A distinction is made
between the following parameterisations:
 system parameterisation, e.g.: switching out fault
messages, setting reaction times,
etc.
 module parameterisation (module and channel−specific),
e.g.: monitoring, settings in the event of faults, settings
for forcing
 parameterisation of the diagnostic memory.
A detailed description of the individual parameters as well as
basic information on application can be found in the CPX sys
tem manual (P.BE−CPX−SYS−...).
The module parameters which are available for the various
modules can be found in the manual for the relevant module
(e.g. manual for CPX pneumatic interfaces and CPX I/O mod
ules (P.BE−CPX−EA−...).