Enter password:
[?xx] =
ESC <menu>
EDIT <––> OK <Enter>
New Password:
[?xx] =
ESC <menu>
EDIT <––> OK <Enter>
4. Control panel (MTR−DCI−...−H2IO)
4−16
Festo P.BE−MTR−DCI−IO−EN en 0606b
Modify/deactivate password
[Password] Select [Settings] [Password] in the menu:
Enter the existing password with 3 figures. The current entry
position is marked with a question mark.
1. Use the arrow buttons to select a figure 0...9.
2. Confirm your entry with OK <Enter>. The next entry
position will be displayed.
3. Repeat the entry for the further entry positions.
4. Enter
the new password with 3 figures. If you wish to
deactivate the password, enter 000".
5. After entering the third figure, save your setting with
SAVE <Enter>.
· Keep the password for the MTR−DCI in a safe place, e.g.
with the internal documentation for your system.
If the active password in the MTR−DCI should be lost in spite
of care being taken:
you can delete the password by entering a master password.
In this case please contact your Festo Service partner.
To Next Page
Loading...
