37
8.7 Power Save Option
This function is important for power conservation. If the power saving function is
not set during battery pack use, the number of splice cycles will be reduced.
(1) Insert a power unit and turn on the splicer.
(2) Select “Power Save Option” in “System Setting” menu.
(3) Change values of “Monitor Shut Down” and “Splicer Shut Down”.
parameter description
Monitor Shut Down
To avoid power loss when battery is used, setting this function turns o
the power supply to the LCD monitor if the splicer does not operate after
a certain period of time. When the power supply for monitor turns o, the
LED near the power key blinks. Press any key to turn on the LCD monitor.
Splicer Shut Down
Automatically turns o the power supply of the splicer if it performs no
operation for a certain period of time. The function serves to prevent the
battery capacity from running low if the splicer is left on for an extended
period of time.
LCD Brightness Adjust LED backlight brightness.
To Next Page
Loading...
