21
② Select Splice Mode
③ Highlight the program you
want to select.
④ Back to initial interface
4.3 General Splicing Steps
This section explains the steps involved in automatic splicing process and describes
how various program parameters are related to this process. The normal splicing
process can be divided into two sections: pre-fusion and fusion.
Pre-Fusion
During pre-fusion, the splicer performs automatic alignment and focusing, where
the bers are subjected to a low pre-fusion current for cleaning purposes; a pre-
fusion image is also taken. At this point, the user is informed of any problems
recognized in the pre-fusion image, such as a poorly prepared ber. The splicer will
then issue a warning before the bers are fused together.
To Next Page
Loading...
