EasyManuals Logo

FiberHome AN5506-04-FS User Manual

FiberHome AN5506-04-FS
146 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #109 background imageLoading...
Page #109 background image
4
Web Configuration Guide
T
able 4.16 Parameters for IPv6 MAC Address Filtering (Continued)
Item Description
filtering rule table will not be allowed to
pass.
MAC
Address
The MAC address in the MAC address
filtering rule.
Start Time
The starting time of the filtering rule.
End Time
The ending time of the filtering rule.
Enable
Enables or disables this filtering rule. The options include
Disable and Enable.
4.4.2
Remote Control
Enable
or disable the remote access control. If the remote control is
disabled, the PCs in the Internet cannot access the Web GUI of the
ONU using the IP addresses at the WAN side; if enabled, the PCs in
the Internet can access the Web GUI.
1. Select Security in the navigation bar and select Remote
Control in the left link bar to open the remote control
configuration tab, as shown in Figure 4.28.
Figure
4.28 Remote Control
2
. Enable or Disable the remote access control as required.
3. Click Apply to save and apply the configuration.
103

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the FiberHome AN5506-04-FS and is the answer not in the manual?

FiberHome AN5506-04-FS Specifications

General IconGeneral
TypeGPON ONT
Power Supply12V DC, 1A
Operating Temperature0°C to 40°C
Storage Temperature-40°C to 70°C
Humidity5% to 95% (non-condensing)
Wi-Fi2.4 GHz
PON InterfaceGPON
Ports4 x 10/100/1000 Mbps Ethernet, 2 x POTS

Related product manuals