FiberHome AN5506-04-FS User Manual

4
Web Configuration Guide
4.5.5
NAT
NA
T can implement the conversion between intranet IP addresses
and public network IP addresses. NAT converts a great number of
intranet IP addresses into one or a small number of public network
IP addresses, so as to save the resource of public network IP
addresses.
The NAT configuration below can take effect only when the NAT
function is enabled in Network→BroadBand Settings.
1. Select Application in the navigation bar and select NAT in the
left link bar. Click Add to open the NAT configuration tab, as
shown in Figure 4.40.
Figure
4.40 NAT
2
. Configure relevant parameters according to the requirement.
Table 4.22 describes the parameters.
3. Click Apply to apply and save the configuration.
116

FiberHome AN5506-04-FS Specifications

General

Type	GPON ONT
Power Supply	12V DC, 1A
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Humidity	5% to 95% (non-condensing)
Wi-Fi	2.4 GHz
PON Interface	GPON
Ports	4 x 10/100/1000 Mbps Ethernet, 2 x POTS