EasyManuals Logo

Fine Offset Electronics WH2950 User Manual

Default Icon
58 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
15
Note: The batteries are intended for back-up power only. The backlight will
remain on for 5 seconds when on back up battery power only. Only when
you use power adapter it will the back-light be continuously on.
3. Keep both sensor and the display console together for 15 minutes to lock in
the sensor signals.
4. (Optional)-Spin the wind cups to simulate wind speed. Take the sensor to the
sink and slowly drip water into the rain bucket to simulate rain.
5. After 15miuntes, follow the mounting instructions for proper placement of
sensors.
Note: Your display console should have readings in all sections. Wind and
Rain will show 0’s (connected) until wind or rian occur or are simulated.
Note: If you only use battery to power up display console, you must press
LIGHT/SNOOZE key to light up the LCD before press any other key.
5.5.1 Vertical Desk Stand
The console is best viewed above from a 20 to 30 degree angle.
In addition to the fold out desk stand on the back of the display, console, the
console also includes a vertical desk stand to improve the viewing able on a
desk, as shown in Figure 13.
Figure 13

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fine Offset Electronics WH2950 and is the answer not in the manual?

Fine Offset Electronics WH2950 Specifications

General IconGeneral
BrandFine Offset Electronics
ModelWH2950
CategoryWeather Station
LanguageEnglish