5.2 HOME Mode: In this operation mode, those burglar sensors with their Enable State – “24-Hour
Zone” or “Guard in Home Mode” = Yes, will still be on alert and offer the protection you
need while at home.
Note: When you set the LS-20 in Home Mode, the Base Unit will check the status of the Door
Magnet sensors. If any of the sensors is still open (for example, you forgot to close the back
door), the Base Unit will keep a “Protection Loop Open” in the Event Log.
The Base Unit will clear any previous alarm and warning status on the LED when the
Home Mode is entered from the Disarm Mode.
Enter into “HOME” Mode from different devices or services.
The Burglar sensor’s “Guard in Home Mode” is enabled.
To Next Page
Loading...