EasyManua.ls Logo

FineControl LS-20 - Remote Siren and Automation Timing

FineControl LS-20
74 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
26
Disarm Exit Delay AWAY ARM effective
System status:
(0-255 seconds)
Set AWAY mode
This Delay only works on the Controller with its Delay Activation = Yes, see below.
* Inner Siren Time: 0-255 seconds (default = 60 sec.)
The time of the Inner Siren sounds when the alarm trips.
*Alarm Siren Action Time: 0 second to 120 minutes (default = 60 sec.)
The activation time of the external Alarm Siren sounds (on the rear panel) when the alarm trips.
*Sensor Supervise Time: 0-24 Hours (default = 12 Hours)
The LS-20 is a supervised RF wireless system, meaning supervised sensors send heartbeat
RF signals to the Base Unit at a certain time interval. If the Base Unit does not receive the RF
check signal from a supervised sensor within the Sensor Supervise Time, the LS-20 considers
this sensor to be missing and issues a warning message.
This time can be set from 0 to 24 hours (0 hour means that the system will not check the
“heartbeat” signal.
Please note, the time shorter than 4 hours would increase sensor RF Loss possibility.

Table of Contents