FINEPLACER
®
lambda
Rev-Nr. 1.1
Content Page Content Page
1 HINTS FOR USING THIS MANUAL 4
2 GENERAL INFORMATION ON
FINEPLACER® SYSTEMS AND THIS
MANUAL 4
2.1 APPLICATION OF THE
FINEPLACER® LAMBDA 4
2.2 OPERATING PRINCIPLE, METHOD OF
WORKING AND SYSTEM FEATURES 6
2.3 METHOD OF WORKING, POSITIONING
AND
PLACEMENT 7
2.4 PURPOSE OF THE EQUIPMENT;
WARNING AGAINST MISUSE;
WARRANTY CONDITIONS 7
2.5 GENERAL SAFETY INSTRUCTIONS:
MASS/ WEIGHT 8
2.6 SAFETY REGARDING ELECTRICAL
MAINS POWER 9
2.7 ELECTROSTATIC DISCHARGE,
ELECTROMAGNETIC COMPATIBILITY 10
2.8 HEAT AND FIRE HAZARDS, RISK OF
BURNS 10
2.9 CONDITIONS OF WORK AREA; OTHER
POSSIBLE HAZARDS 11
3 THE FINEPLACER® SYSTEM 13
3.1 INTRODUCTION 13
3.2 MAJOR ASSEMBLIES OF THE BASIC
EQUIPMENT 13
3.2.2 SUPPORT ARM (71), HOLDING THE
FOLLOWING PARTS
: 16
3.2.3 PIVOT ARM (27) 16
3.2.4 PLACER CONTROL BOX 17
3.3 SHORT DESCRIPTION OF BASIC
FUNCTIONS AND DIRECTIONS FOR
INSTALLATION 18
3.3.1 MAINS CONNECTION 18
3.3.2 DISPLAYS AND OPERATING ELEMENTS18
3.3.3 GENERATION AND CONNECTION OF
VACUUM AND COMPRESSED AIR 19
3.3.4 PLACER SUPPORT 19
3.3.5 CAMERA CONTROL AND POWER
SUPPLY FOR OPTIONS 19
3.3.6 RS-232 INTERFACE 20
3.3.7 FINETECH MODULE INTERFACE 21
3.4 OPERATING INSTRUCTIONS FOR THE
PLACER CONTROL BOX 21
3.4.1 SWITCHING ON 21
3.4.2 CONTROLLING THE BRIGHTNESS 22
3.4.3 UNDERSTANDING THE VACUUM
CONTROL 22
3.4.4 VACUUM CONTROL SAFETY SYSTEM 23
3.5 PARTS, CONTROLS AND INDICATORS 23
4 INSTRUCTIONS FOR SET-UP 27
4.1 INITIAL SET-UP OF THE
FINEPLACER® 27
4.1.1 PREPARATION OF THE BASIC
COMPONENTS AND SUBASSEMBLIES 27
4.1.2 PREPARATION OF THE POSITIONING
TABLE'S HEIGHT ADJUSTABLE
TRACKS 27
4.1.3 PROVIDING SUITABLE PLACEMENT
HEADS FOR THE PIVOT ARM 28
4.1.4 INTERCONNECTION OF THE LAMBDA 28
4.1.5 PRELIMINARY SETTINGS AND
CHECKOUT 29
4.2 ADJUSTING THE PLACEMENT
ACCURACY OF THE LAMBDA 29
4.2.1 REQUIRED TOOLS: 30
4.2.2 DISTINGUISHING BETWEEN LAMBDA
A6, A7 AND A7+ 30
4.2.3 ADJUSTING THE PLACEMENT
ACCURACY 30
4.3 ADJUSTING THE PLACEMENT ARM'S
COPLANARITY 35
5 OPERATING INSTRUCTIONS 38
5.1 ADJUSTABLE LOCK POSITION FOR THE
MANUAL OPTICS SHIFTING
38
5.2 LOADING THE COMPONENT FOR
PLACEMENT 39
5.3 ALIGNMENT 39
5.4 PLACEMENT 39
To Next Page
Loading...