FINEPLACER
®
lambda
Rev-Nr. 1.1
Re-assemble the cover.
6.1.6 Yearly
Depending on the degree of accuracy needed for your task, check the possible
accuracy of placement and re-adjust if required (see chapter 4.2). Checking the
adjustment is also recommended after transportation
6.2 Corrective Maintenance
• All machine parts are manufactured using quality devices and are subjected to
the most rigorous electrical and mechanical controls. Each FINEPLACER
®
product is tested as a unit before leaving the facility. Premature failure is
therefore unlikely.
• In case of failure call, fax or mail your dealer or the manufacturer Finetech.
You find the contact address on the first page of this part of the manual.
• Corrective maintenance essentially consists of identifying a defective
component, removing it from the lambda and returning it to Finetech for
repair or replacement.
• Finetech will also help you to identify the fault and give advice if you want to
carry out repairs yourself.
• Before dismantling defective parts, please contact Finetech or your repre-
sentative!
• Before sending anything, please agree what, when and how to dismantle, and
the best method of return.
To Next Page
Loading...