FINEPLACER
®
lambda
Rev-Nr. 1.1
Under no cirscumstances press the pedal unless both hands are on the
positioning table. Risk of damage or injury.
With activated air cushion, the positioning table’s outer edges can be moved beyond
the edges of the base plate.
Make sure that the table is not placed in an extreme position that is unsuitable for
work.
Damage can occur here due to incorrect behavior of the operator (by leaning or
putting weight on the table).
Make sure the base plate has been adjusted correctly (see 3.2 Major Assemblies of
the Basic Equipment).
2.6 Safety Regarding Electrical Mains Power
Be cautious of electrical hazards:
No wet hands, no children, no plants and no animals should come into contact with
any machine part. Always keep the equipment dry. No thin or small electrical
conducting parts (e.g. cut wires, washers) should come in the close vicinity of the
machine's electrical equipment, into connectors, or especially into ventilation slots.
Before you disconnect from the mains:
• Lay down the pivot arm and switch OFF the electrical power.
• To connect the mains, first put the (female) plug into the control box socket,
and then the other (male) plug into the (wall) outlet; disconnecting in reverse
order.
• Never pull/push leads and hoses with the lead outside the plug. Always hold
the plug in your hand.
Two-handed handling of the positioning table
To Next Page
Loading...