FINEPLACER
®
lambda
Rev-Nr. 1.1
equipment and must not be run without being combined with our Base Module as
specified.
National and international standards and regulations for minimizing the risk of
serious injury are, as far as possible, taken into account in the development and
production of this equipment as applicable to ("Conformity", "CE"), but danger
caused by improper use or by breakdown remains.
The operator of the equipment is responsible for carrying out safety checks as stated
in the manual and should not hinder or diminish these by conditions of the working
place and its surroundings.
Manufacturer and contractor are not liable for damages or injuries caused by
improper use or unsuitable work.
The FINEPLACER
®
comes with a year’s guarantee that equipment will be free from
malfunctioning, material defects, and manufacturing faults, under the condition that
the equipment is used for its intended purpose only and under the specified
conditions of use, and does not extend to tools, wear and tear, glass, bulbs and
rubber parts. During the guarantee period, equipment that does not work perfectly
will be repaired or exchanged free of charge.
The guarantee only covers the aforementioned FINEPLACER
®
equipment, but no
consequential damage of any kind arising from breakdown, malfunction or improper
use of the equipment.
2.5 General Safety Instructions: Mass/ Weight
Some of the FINEPLACER
®
modules are heavy and may cause damage or be
damaged by inattentive transportation or use.
Before setting up the system, make sure that the working table can bear sufficient
load to carry the machine and its accessory. Further, check if the table is mounted in
a technically correct manner. In case of using a height adjustable table, check the
safety clamping of the height adjustment mechanism. Commercial damage or
personal injury caused by neglecting the above safety measures is not covered by
Finetech's responsibility.
Arrange cables and hoses so that nobody can get caught.
If you want to move the machine, first disconnect all cables and hoses and take the
positioning table off the base plate.
Before moving the air-bearing positioning table both hands have to be placed at the
table.
Press the pedal to move the table and keep both hands always at the table while
moving it around.
To Next Page
Loading...