8
STARTING THE ENGINE:
CAUTION: See safety section of the manual (pages 2-4) before operating
the machine.
1. Be sure that the clutch is disengaged and that the power feed handle is in the "Off" position.
2. Turn ignition switch to "START" position. If engine does not start within 10 seconds, turn the key
back to the "Off" position and wait at least 30 seconds before trying again.
NOTE: This engine has a safety system that will shut the engine off if the
engine oil pressure drops below 7 psi (48 kPa), or if the water tem-
perature reaches 239˚F (115˚C).
3. Allow the engine to warm up at fast idle for 3 to 5 minutes.
4. The engine information display will show the current engine conditions. The display can be cus-
tomized to show different engine parameters (RPM, hours, volts, coolant temperature, etc.). See
"PowerView" on pages 9-11.
5. With the engine still idling, engage the clutch slowly. Move the throttle to wide-open position and
let the governor control the engine speed. Governed speed of the engine on the Finn Straw Blower
should be 2550 to 2600 RPM under load.
CAUTION: Before engaging the clutch, be certain that the discharge tube
is under control and is pointed in the proper direction.
IMPORTANT: After the first 4 to 8 hours of operation, the drive belt should
be checked and retightened (see pages 16-17) , and the clutch
checked and adjusted (see page 19).
To Next Page
Loading...
