158 MS-9600LS Series Manual — P/N 52646:B8 11/20/2015
Appendix B: Default Programming
The following table provides a list of the programming options and their factory default settings.
Program Option Factory Default Program Option Factory Default
Master Password 00000 NAC Enable Enabled
Maintenance Password 11111 NAC Silenceable Yes
Detector Programming Not Installed NAC Type Bell
Detector Type Smoke-Photo NAC Sync Type System Sensor
Detector Verification Off NAC Autosilence 0
Detector Walktest Yes NAC Coding Steady
Detector PAS No NAC Zones Zone 000 only
Detector Presignal No NAC Silence Inhibit 0
Detector Zone Assign. 000 only Relay 1 Alarm
Detector Adj/Noun none Relay 2 Trouble
Module Programming Not Installed Relay 3 Supervisory
Module Type Monitor On Board DACT No
Module Walktest Yes Annunciator Terminal Mode No
(not used) Annunciator ACS Mode No
Module Presignal No UDACT No
Module Zone Assign. 000 only ACS Installed No
Module Adj/Noun none Printer-PC No
Zone 0 Enable Enabled Printer Baud 9600
Zone 1 Enable Enabled Canadian Option Off
Zone 2 Enable Enabled Waterflow Silenceable No
Zone 3 Enable Enabled MNS Override No
.........................through.......... ..................... ANN-BUS Enabled No
Zone 99 Enable Enabled Central Station Reporting Disabled
Special Zones 97, 98 & 99 Disabled AC Loss Delay 2 Hours
Zones 0 - 99 Type Monitor DACT Backup Reporting First Available
Loop 1 & 2 Style Style 4 DACT Report Style By Point
Loop 1 & 2 Protocol LiteSpeed ANN Enabled No
Trouble Reminder Off ANN-BUS Modules Addr. 1 - 8 None
Banner ANN-S/PG Port Parallel
Time Format 12 Hr ANN-S/PG Baud 9600
Hours Setting 12 ANN-S/PG Data Bits 7
Minutes Setting 00 ANN-S/PG Parity Even
Second Settings 00 ANN-S/PG Stop Bits 1
AM-PM Setting AM ANN-S/PG Offline Timer 60
Month Setting 01 ANN-S/PG Printer Supervision No
Day Setting 01 ANN-80 Piezo Enabled Yes
Year Setting 00 ANN-80 Lock Enabled Yes
PK-Plus Secret Code 00000000 ANN-80 Acknowledge Button Enabled Yes
Trouble Call Limit 0 ANN-80 Silence Button Enabled Yes
Daylight Savings Yes ANN-80 Reset Button Enabled Yes
Month Start Daylight Savings March ANN-80 Drill Button Enabled Yes
Week Start Daylight Savings 2nd Week ANN-I/O Point/Zone Zone
Month End Daylight Savings November ANN-I/O Range 00-29
Week End Daylight 1st Week ANN-I/O Active LEDs Only
Verification No ANN-RLY Relay 1 Zone 1
Ring Count 0 ................through....................... ............
PAS Timer 0 ANN-RLY Relay 10 Zone 10
Presignal Timer 0 ANN-LED Point/Zone Zone
Waterflow Retard Timer 0 ANN-LED Alarms/ATS (Alarm, Trbl, Supv) ATS
ANN-LED Range 0 - 9
To Next Page
Loading...
Need help?
General
