FireClass FC506 - Parts identification

18
Figure 7: FC500 repeater installation
Inserting the LED and keys labels in the repeater user interface
To insert the LED and keys labels in the repeater user interface, work through the following steps. See Figure 7.
1. Remove the screws, and open the Repeater FC500. Corresponding to the A or B in the overlay, insert the relevant
LED and keys Labels. See Figure 7, item 10.
2. Check that the labels are correctly inserted and close the repeater FC500.
1
Holes for cabinet mounting (4)
2
Screws to secure main module (4)
3
Connector for the repeater RS485
interface
4
Earthing cable
5
Terminal for the earth connection wires
6
LED label slot
7
User interface repeater board
8
Knockouts for cables ducted externally
(4)
(One on each side)
9
Hooks to secure the cover on the panel
(2)
10
Screws to secure cover (2)
11
Repeater panel cover