Camera status
Once the camera is properly powered up by following the steps of section 7, the system boots and C-
RED 3 is ready to operate.
A purple diode signal, visible on the rear face of the camera, confirms the operability.
Camera configuration is applied
Safe Red double blink The camera detects an error. The detector is
turned off. To be able to reuse the camera, you
must restart it.
The camera detects a critical error. The camera is
unusable, please contact First Light Imaging for
Safe (rescue FW) Orange double blink The camera detects a critical error. The camera is
unusable, please contact First Light Imaging for
Note: turned off led does not necessary mean that there is an issue with the camera. Indeed, the
camera can be configured to switch off the led automatically once boot is completed.
To Next Page
Loading...
