Thermal protection
In case of overheating or too cold temperature depending on external operating conditions, the camera
will automatically shut down itself to protect electronic components.
Please note that it is not possible to switch off this functionality.
The internal firmware monitors at each time the temperatures on different parts and boards. Each
temperature must be in the accepted range described in the following table.
To recover the use of the camera, after the camera went back in the authorized range of temperature,
the user must reboot the camera by unplugging/plugging the power, as described in paragraph “7.3
Powering up/down”
.
Camera presets
C-RED 3 allows to store up to ten different user configurations, called presets.
Presets contain all parameters settable by user, plus corresponding bias and file correction files.
Using presets allow to switch easily from one configuration to another, without need to rebuild
correction files.
A specific preset is selected using the “preset <n>” command. After loading a preset, the user is free
to change any parameter. Changes can then be saved in the current present using the “save”
command.
At any time, the current preset can be reloaded by using the “preset” command. All changes in the
running configuration not previously saved will then be lost.
Factory camera presets can be restored using the “restorefactory” command.
Camera optional features.
C-RED 3 camera is provided with HDR optional feature. This extra feature is enabled through license
file uploaded into the camera during the production, or later directly by the customer.
The transfer of a license file into the camera is done using serial link connection, using either
“sendfile license” or “xsendfile license” command.
A license file previously uploaded into a camera can be removed using the “exec dellicense”
command.
To Next Page
Loading...