First Light C-RED 3 - 10. Description of Various Fonctions; List of Available Commands

54
10. DESCRIPTION OF VARIOUS FONCTIONS
The list of available commands of the camera can be displayed using ‘help’ command in the terminal
of the demo GUI software. The available commands are listed below.
List of available commands
COMMANDS
DESCRIPTION
hwfeatures
Get camera HW features (FW 1.1.0 or above)
Swfeatures Get camera SW features (FW 1.1.0 or above)
temperatures
Get temperatures
temperatures CPU Get CPU temperature
temperatures backend
Get back-end board temperature
temperatures interface Get interface board temperature
temperatures snake
Get sensor temperature
temperatures ambiant Get ambient temperature
tlsydel
Get tlsydel delay
fps Get acquisition frame rate (fps)
minfps
Get the minimum acquisition frame rate according to
current camera configuration
maxfps Get the maximum acquisition frame rate according to
current camera configuration (Camera Link)
maxfpsusb
Get the maximum acquisition frame rate according to
current camera configuration (USB)
tint
Get integration time (seconds)
mintint Get minimum integration time according to current
camera configuration (seconds)
maxtint
Get the maximum integration time regarding current
camera configuration (seconds)
maxtintitr Get the maximum integration time without
integration/read overlap regarding current camera
configuration (seconds)
tintgranularity
Get the integration time granularity status when
operating in IWR mode
Tintstep
Returns the minimal integration increment according
to current camera configuration (FW 1.3.0 or above)
tcdsadjust Get TCDS automatic adjustment status for low
integration times
vrefadjust
Get VREF automatic adjustment status
bias Get bias correction status
adaptbias
Get adaptative bias status
flat Get flat correction status
badpixel
Get bad pixel correction status
imagetags Get tag generation status
led
Get current LED status