First Light C-RED 3 - Page 61

61
set sensibility high Set highest sensitivity (deprecated FW 1.2.0)
set sensitivity low
Select lowest camera sensitivity (FW 1.2.0 or above) –
Replaces sensibility
set sensitivity medium Select medium camera sensitivity (FW 1.2.0 or above)
set sensitivity high
Select high camera sensitivity (FW 1.2.0 or above)
set snake <parameter> <value> Set snake config parameter (deprecated FW 1.3.0)
set sensor <parameter> <value>
Set snake config parameter (replaces snake) (FW 1.3.0
or above)
set preset Reload currently active camera settings preset
set preset 0
Load camera settings preset #0
set preset 1 Load camera settings preset #1
set preset 2
Load camera settings preset #2
set preset 3 Load camera settings preset #3
set preset 4
Load camera settings preset #4
set preset 5 Load camera settings preset #5
set preset 6
Load camera settings preset #6
set preset 7 Load camera settings preset #7
set preset 8
Load camera settings preset #8
set preset 9 Load camera settings preset #9
set aduoffset <aduOffsetValue>
Set ADU offset value applied to each pixel in the
acquired frames
set unsigned on Request camera to send unsigned pixels (not
applicable for HDR mode, see hdr extended). (FW 1.3.0
or above)
set unsigned off Request camera to send signed pixels (not applicable
for HDR? See hdr extended) (FW 1.3.0 or above)
set syncdelay <delay>
Set delay for external synchronization signal
set hdr on Enable HDR (FW 3.1.1 or above)
set hdr off
Disable HDR (FW 3.1.1 or above)
set hdr extended on Enable extended HDR (unsigned pixels) (FW 3.1.1 or
above)
set hdr extended off
Disable extended HDR (unsigned pixels) (FW 3.1.1 or
above)
set hdr calibration c1 Force usage of C1 in HDR (used for bias/flat
computation)
(FW 3.1.1 or above)
set hdr calibration c2 Force usage of C2 in HDR (used for bias/flat
computation)
(FW 3.1.1 or above)
set hdr calibration off
Disable HDR calibration (FW 3.1.1 or above)
set darkoptimlevel <value> Set tradeoff between dark current and noise (in
percent)
(FW 3.1.1 or above)
set agc on
Enable AGC
set agc off Disable AGC
set agc param level_pix_high_hg <value>
Set overexposed pixel level in high gain
set agc param level_pix_low_mg <value> Set underexposed pixel level in medium gain