EasyManua.ls Logo

Fischer Panda 10000i PMS - Page 86

Fischer Panda 10000i PMS
204 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Installation Instructions
Seite/Page 86 - Kaptitel/Chapter 5: Installation Instructions 15.2.13
Fig. 5.11.1-1: Positive Battery Cable Positive battery cable
The positive (+) battery cable is connected directly to the solenoid switch of
the starter.
Fig. 5.11.1-2: Negative Battery Cable
Negative battery cable
The negative (-) battery cable is connected to the engine foot.
Note! The battery negative pole may not be connected with the
boat ground or with the protective grounding of the 120 V
installation!
Fig. 5.11.1-3: DC Starter Motor DC Starter Motor
All Panda generators are equipped with an independent DC starter motor.
1. Solenoid switch for starter motor
2. Starter motor
1
2

Table of Contents