Need help?Do you have a question about the Fisher Scientific Isotemp Basic -86C and is the answer not in the manual?
General| Brand | Fisher Scientific |
|---|---|
| Model | Isotemp Basic -86C |
| Category | Freezer |
| Language | English |
Important safety and operational guidance for installers and users.
List of components included with the freezer.
Explanation of control panel buttons, displays, and indicators.
Instructions for operating the freezer's keypad and modes.
Instructions for removing the freezer from its pallet and positioning it.
Guidance on selecting an appropriate and safe location for the freezer.
Steps for installing wall bumpers for freezer stability and protection.
Procedure for installing shelves inside the freezer cabinet.
Details on connecting the freezer to an external alarm system.
Instructions for connecting the power cord to the freezer inlet.
Steps for connecting the freezer to a grounded electrical power source.
Procedure for the initial power-up and configuration of the freezer.
How to adjust the primary temperature setting of the freezer.
Procedure for configuring the upper temperature limit alarm.
Procedure for configuring the lower temperature limit alarm.
Description of the default operating mode and how to navigate it.
Instructions for calibrating the freezer's temperature control probe.
Overview of freezer alarms, including delay, ringback, and relay status.
Condition when high stage compressor/fans fail to cool properly.
Condition when control, heat exchanger, or condenser probes fail.
Details of specific error codes (Er00, ErA1, etc.) and their responses.
Procedure for cleaning the freezer's air filter.
Instructions for cleaning the condenser fins.
Procedure for cleaning a water-cooled condenser using CIP.
Steps for defrosting the freezer chamber.
Guidance on preparing the freezer for periods of storage.
Instructions for cleaning the freezer's door gasket.
Procedure for cleaning the vacuum relief port to ensure proper function.
Steps for replacing the freezer's internal battery.
Procedure for checking the voltage level of the freezer battery.
Schedule of recommended monthly, yearly, and bi-yearly maintenance tasks.
Steps for installing the injection assembly, vent stack, and solenoid.
Procedure for installing the temperature probe for the BUS system.
Instructions for connecting the probe and solenoid harness to the BUS system.
Explanation of the BUS control panel indicators and buttons.
Steps to configure the BUS system for LN2 or CO2 supply.
Procedure for setting the temperature set point for the BUS system.
How to test the functionality of the BUS back-up system.
Procedure for cleaning the vent stack of frost or ice build-up.
Steps for disconnecting the BUS system from the gas supply.
Instructions for installing new paper into the chart recorder.
Procedure for changing the temperature range settings on the chart recorder.
Steps for calibrating the chart recorder against an accurate thermometer.
Details on product certifications and conformity declarations.
Environmental and operational safety parameters for the freezer.
Description of the product's intended applications and limitations.
To Next Page
