Fisherbrand 50152755 | 27
Operation
Preparing the Incubator
The incubator must not be released for operation before all major start-up activities have been
completed (see Chapter 5, “Start-up.” ).
Device Check
Prior to starting operation, the following incubator components must be checked for their correct
function:
The door seal in the front frame must not be damaged.
The glass door must not be damaged.
The shelving components must be installed safely.
Disinfecting the Incubator’s Work Space
Disinfect the work space according to the operator-specified hygiene guidelines.
Starting Operation
1. Turn the incubator on using the control panel.
2. Adjust the temperature set value on the control panel.
3. The temperature controller starts adjusting the work space to the user-specified temperature
set value now.
To avoid any risk of explosion or fire
• refrain from loading the incubator with any of the substances listed in the section
“Incorrect Use” on page 5
• make sure that the ambient air is free of any solvents
• do not operate the incubator in areas with an explosion hazard
To Next Page
Loading...