Fisherbrand 50152755 | 35
Cleaning and Disinfection
Cleaning
Cleaning Exterior Surfaces
Remove dirt residues and depositions thoroughly using a solution of lukewarm water and
commercial detergent.
Wipe the surfaces clean using a clean cloth and clear water.
Then, wipe the surfaces dry using a clean cloth.
Wipe / Spray Disinfection
The manual wipe and spray disinfection is a three-stage process:
predisinfection,
cleaning,
final disinfection.
Incompatible cleaners
Some incubator components are made of plastics. Solvents may attack plastics.
Strong acids or alkaline solutions may cause embrittlement of plastics.
Please consult the manufacturer or his agent if there is any doubt about the
compatibility of decontamination or cleaning agents.
Moisture-sensitive components
Do not spray cleaning agent onto the control panel and the interfaces at the rear of the
incubator. When wiping the incubator clean, always make sure that no moisture enters
into these components.
Wipe the display window down with a slightly dampened cloth, then wipe dry with a
rag made of 100% microfiber.
To Next Page
Loading...