Note:
Do not charge the battery via the Type-C port on the handle while the device
is in use.
Use the Type-C port on the side of the LiDAR module when you have to
charge the battery during use. Only use the charger provided.
Charge the battery when the battery level is low to avoid over discharge.
To extend the battery's service life, charge the battery at least once every 3
months.
After 800 charge and discharge cycles, the battery capacity naturally drops to
80% of its original capacity.
When only one light of the battery level indicator flashes, charge the battery
immediately to avoid shutdown during use.
3.3 Using the Camera
3.3.1 Camera settings
As shown in Figure , press and hold the power button until the touchscreen lights
up. For details about how to set the video recording parameters, see the Insta360 X3
User Manual provided. The following table lists the default camera settings.
To Next Page
Loading...