Flashforge Creator Pro - Recommended Gcode Settings for ABS and PLA

FLASHFORGE 3D PRINTER
10
Recommended GCode Settings for ABS and PLA
A new window will open up, giving you several options on how the Gcode will be generated:
ABS:
And set HBP at 90
Note: The HBP temperature is related with the temperature of the surroundings and the size of the model.
At the room temperature of 20℃, to print a square of 20x20 mm, the HBP temperature is generally 90℃. If
the temperature of the surroundings drops (below 20℃), or the size of the model is bigger, then the HBP
temperature should be increased accordingly to avoid warping, but not exceed 120℃.
PLA:
And set HBP at 50
Note: The HBP temperature is related with the temperature of the surroundings and the size of the model.
At the room temperature of 20℃, to print a square of 20x20 mm, the HBP temperature is generally 50℃. If