FLASHFORGE 3D PRINTER
Click ‘Close’ on the Preferences menu and you are done!
The machine will now work as normal when generating Gcode. Now we will start a preliminary test on the
machines connections and we will heat the platform and extruder ready for printing.
USB connection
First, connect the machine and computer with the provided USB A to B cable.
The USB port on the machine is bound by the red box in the above image. After connecting the cable, open
the Replicator G software, we are going to connect the computer and printer.
Click Machine > Connection (serial port) > Rescan serial ports, if no new ports appear then the software
driver has not been installed. To install the driver manually, click 'My computer' then right click ‘properties’,
the basic system parameters appear. Then select ‘Device Manager’.
To Next Page
Loading...
