————————————————————————————————————————————
Raft: This function will help the model to stick well on the platform.
Wall: During dual color printing, this function will help to clear the leaking filament of another
extruder.
Vase Mode: No capping for the model
You have three resolution solution (with default setting) to choose from, high resolution is
corresponding with slow printing speed, opposite for the low resolution. For PLA printing, an
extra solution “Hyper” is available.
Click [More options] to set for layer, shell, infill, speed, temperature.
Different resolution solution is corresponding to different defaults, click [Restore Defaults] to
back to default setting.
Layer
a. Layer Height: Layer thickness of the printing model. With a small number, the surface of the
model will be smoother.
b. First Layer Height: This is the first layer of the model, which will affect the sticking performance
between the model and platform. Maximize is 0.4mm, usually the default is OK.
c. Shell: Contains of the outside shell number, capping layer number (under vase pattern, top
solid layer setting is invalid.)
Primeter Shells: Maximize is 10
Top Solid Layer: Maximize is 10, minimum is 1.
Bottom Solid Layer: Maximize is 10, minimum is 1.
Infill
a. Fill Density means fill rate.
b. Fill Pattern is the pattern of filling shape which effects printing duration.
Speed
Print Speed is the moving speed of the extruder. Generally, the lower speed, the better print you
will get. For PLA printing, 80 is recommended.
b. Support Print Speed is needed to set when choosing Slic3r as the slice engine which can
To Next Page
Loading...
