————————————————————————————————————————————
Save
After finishing the model edit and adjustment, there are two ways below to save all models in the
scene.
Method 1:
Click [File]--[Save Project] in the menu bar, can save the file as a project file which suffix is ”.fpp”
in this type of file, all models in the scene (include support) are independent .after reloading the
files, extruder configuration information and model position will be as same as the configuration
during saving.
Method 2:
Click on [File]--[Save as...] to save the model as project file .fpp or .stl and .obj. For .stl and .boj,
models are integrated as one (include support part). If load it again, only the position of the
model was saved, not included the printing parameters.
Print
Pattern
Step 1: Click [Print]--[Print] or click the Print icon on main interface, dialog of slicing parameters
will show up.
Step2: After the setting of slicing parameters, click [OK] and a dialog for saving Gcode will pop up.
Step3: Choose a save path and click the [Save] button, slicing will begin and a progress bar will
appear. If you want to stop, click the [Abort] button to stop slicing.
Slicing Parameters
Preview: Choose to enter preview interface or not
Print when slice done: Print or not when slice done
Material type: Choose according to the type of model
Supports: When print with model contains part hanging in the air or top-heavy, support is
necessary. Click [supports] to create support part for the printing.
To Next Page
Loading...
