Flashforge Finder - Chapter 4: Hardware Assembly; 4.1 Filament Installation

Finder User Guide | www.ff3dp.com
24
Chapter 4: Hardware Assembly
Your Finder has been installed before leaving factory, you can start up the Finder for
printing after mounting the filament spool and completing leveling.
4.1 Filament Installation
4-1
(4-1) The filament cartridge is at the rear of Finder. Lift the cartridge out of the
Finder.
4-2
(4-2) Take out the filament and thread it through the filament detecting equipment.
Filament Detecting
Equipment