Flashforge Finder - Chapter 5: Build Plate Leveling

Finder User Guide | www.ff3dp.com
29
Chapter 5: Build Plate Leveling
Finder creatively adopts three-point intelligent leveling system, which will give clear
and comprehensive feedback to the users. There are three spring-loaded knobs under
the build platform. The distance between the plate and nozzle increases while
tightening the knobs. On the contrary, the distance reduces.
5-1
(5-1) Tap [Tools] - [Level] on your Finder touch screen. Please wait while the
extruder and platform finish initial movements. After that, you should operate
according to the guide on the touch screen.
5-2
5-2