Flashforge Finder - Chapter 5: About Software; 5.1 Software Installation; 5.2 Exploring FlashPrint

Finder User Guide | www.ff3dp.com
32
Chapter 5: About Software
5.1 Software Installation
5.1.1 Software Acquisition
Method 1: To get the installation package from the USB disk in the toolkit.
Method 2: Open the link below to download the installation package:
http://www.ff3dp.com
Steps: Support---Downloads---Finder FDM 3D Printer
5.1.2 Software Installation and Start-up
1. Decompress the zipped file or start the installation program, and then install the
software according to the direction.
2. Start the software with the start menu shortcut or by clicking the software icon.(See
5-1)
5-1
5.2 Exploring FlashPrint
5. 2.1 Machine Type Selection
! After starting FlashPrint, you need to select the target machine type first.
When you start FlashPrint, a dialog box will pop up. Just need to select Flashforge