Flashforge Finder - Page 65

Finder User Guide | www.ff3dp.com
65
②Turn on the Finder. Make sure the build plate has been leveled and the filament is
loaded.
③
Tap [Print] and then tap the SD Card icon in the middle. The file(s) will display on
the screen., Select the file you want to print and tap [Print]. The file will be
transferred the printer.
⑥And the printer will heat up the nozzle automatically and start to print after the
nozzle reaches the aimed temperature.,
Abort
：
To stop heating and printing. Once you tap [Abort], the process is irreversible.
Pause：To suspend the print job, you can tap it again to resume it. It’s usually used
when you want to change the filament halfway.