Flashforge Finder - Page 67

Finder User Guide | www.ff3dp.com
67
Thickness of each layer. The less thickness of layers, the more time will be used and
the better model will be printed.
b. First Layer Height
When printed with thinner layers, comparative thicker bottom layer could improve
adhesion and tolerance for non-perfect build plates.
2）Speed
a. Base Print Speed: The fiducial value of extuder’s movement speed during
printing(For subsequent speeds counting ). With a lower speed, the printer can build
an objects with higher resolution and more smoothness.
b. Speed at which extruder moves when not extruding filament.
c. Minimum Speed: The minimum extruder’s movement speed during printing
d. First Layer Maximum Speed: The max printing speed for printing the first
layer(Note: It’s invalid to the model which has a raft )
e. First Layer Maximum Travel Speed: The max travel speed for printing the first
layer(Note: It’s invalid to the model which has a raft )
3）Temperature
It displays the temperature of “Extruder”.
4）Retraction
a. Retraction Length: Amount of retraction. Retraction can help users reduce stringing
or oozing during printing. (The default value shall be suggested.)
b. Speed: Speed at which the filament is retracted. The default value shall be
suggested.