Flashforge Finder - Page 71

Finder User Guide | www.ff3dp.com
71
3）Linear
a. Speed: Speed at which the linear supports are printed.
b. Space to Model(X/Y): The gap between the treelike supports and the model contact
surfaces (in the X/Y directions).
c. Space to Model(Z): The distance between the treelike supports and the model
contact surface (in the Z direction).
d. Path Space: The distance between the adjoining paths.
Additions
1）Raft
a . Enable Raft: Enable to print raft during printing. Raft could help the model stick to
the build plate.
b. Margin: The distance between raft’s outline and outline of model’s first layer. If the
raft is enabled, the extra raft area around the object is also enabled. Increasing the
margin will create a stranger raft while using more matrial and leaving less area for
your object.
c. Space to Model(Z): The gap between the raft top and the model’s first layer.