2.3 Features
2.4 Applications
2.5 Terms
The mass per unit volume of materials in a
Material
density
There are two materials (support material and
part material)) to print a three-dimensional solid
model. Support material is a kind of wax, which
adhere the model to the build plate and used to
support the hanging part model. The part
connected to the build plate via support material
after modelling.
3D printing
technology
Detachable platform for model building. Use the
supporting material to paste the part and the
build plate, and it will be removed from the
printer after printing.
Build plate
The precision of the image, WaxJet® 400/410 uses
the unit of DPI to describe.
Resolution
It is a kind of modeling wax. You must wear
nitrile gloves, lab coats and protective glasses
when handling any material. The materials are
provided to the printhead through umbilical as
needed.
part wax
The temperature at which the solid state and
liquid state of the materials are in equilibrium
under a certain pressure.
Melting
point
The temperature of material softens, which refers
to the temperature at which the amorphous
polymer starts to soften.
Softening
Point
It is used to maintain the printhead.
HMS
Uncured support and/or part materials
produced during the modeling process. When
disposing of any waste, it must wear nitrile
gloves, lab coats and protective goggles.
Waste
material
A casting process via soluble and disposable
materials; an industrial process based on
lost-wax casting.
Investment
casting
A material for wax base: to connect the model
with the build plate, to support the suspended
structure and hollow structure.
Support
wax
be used to solve potential problems that may
produced with the 3D printer system.
Log
output of liquid from the designated hole.
in the surface of the model, thus making the
decoration.
Post-
processing
The left to right direction on build plate.
Micro Piezo
Nozzle
the printing process, so that the size of the
produced model can be closer to the actual size.
Shrink rate
The user interface is located on the left side of the
printer. Use UI to control or check a variety of
materials, printer shutdown, etc. You can also
check some settings in the printer.
User
interface
(UI)
X-axis
The front to back direction on build plate.
Y-axis
The top-down direction on build plate.
Z-axis
(CAD) software, which is used to produce parts.
.stl file
data to 3D printer.
WaxJetPrint
01 02 03 04 05 06 07 08
09
10 11 12 13 14 15 16 17
18 19 20 21 22 23 24 25 26
27 28 29 30 31 32 33 34 35
36 37 38 39 40 41 42 43
44 45 46 47 48 49 50 51
52 53 54
55 56 57 58 59 60 61
62 63 64 65 66 67 68 69
70 71 72 73 74 75 76 77
78 79 80 81 82 83 84 85
86 87 88 89 90 91 92 93
94 95 96 97 98 99 100 101
102 103
To Next Page
Loading...
