Chapter 7 After-processing Guide
The after-processing guide is the standard guide of remov-
ing FFMS3100 support. Please prepare some The actual
results may be somewhat different from the following
process. Please prepare the items in the next column before
the procedure. Also, make sure that the room where the
execution is performed is well ventilated or that the ventila-
tion cover is placed.
1. Place the build plate on the heated platform of the magnet-
ic agitator. Remove the model one by one when the support
material is softened.
support wax.
pre-prepared solvent should be shaken well before use.)
Dissolved solvent II, used second to wash the remaining
support wax in detail.
pre-prepared solvent should be shaken and mixed before use)
Dissolved solvent III, which be used to clean the remaining
solvent.
3. Put the beaker and other containers on the magnetic stirrer;
add dissolved solvent I and turn on the heating to keep the
Note: there are a lot of thin printed objects on the
build plate, please start heating from the all around to
the center and remove the model carefully.
7.1 Support removal
Note: please twear protective mirrors, dust masks and
rubber gloves before removing the support.
· Magnetic agitators
· Isopropanol
· The protective mirror
· Beaker
· PPG400
· Dust masks
· The net basket
· Waterless ethanol
· rubber gloves
01 02 03 04 05 06 07 08
09 10 11 12 13 14 15 16 17
18 19 20 21 22 23 24 25 26
27 28 29 30 31 32
33 34 35
36 37 38 39 40 41 42 43
44 45 46 47 48 49 50 51
52 53 54
55 56 57 58 59 60 61
62 63 64 65 66 67 68 69
70 71 72 73 74 75 76 77
78 79 80 81 82 83 84 85
86 87 88 89 90 91 92 93
94 95 96 97 98 99 100 101
102 103
To Next Page
Loading...
