4. Remove the support materials
Before dissolving the support, part of the support material
can be stripped with tweezers to reduce the support removal
time.
8. Check the degree of dissolving of the support material
every 1 minute.
9. Please take out the models on which the support material
has been removed; do not let the models be immersed into
the solvent for a long time.
Note: The dissolving effect of solvents decreases with
the increase in the number of uses, will not easily to
remove the support materials. FlashForge recom-
mends that no more than 100-120 grams of support-
ing material dissolved per liter of dissolved solvent.
5. Put the models into the mesh basket; please do not put too
many models for one time to avoid collision.
keep a distance from the stirrer.
7. Turn on the stirring and gradually increase the rotating
and the speed shall not too fast to shake the models.
01 02 03 04 05 06 07 08
09 10 11 12 13 14 15 16 17
18 19 20 21 22 23 24 25 26
27 28 29 30 31 32 33
34 35
36 37 38 39 40 41 42 43
44 45 46 47 48 49 50 51
52 53 54
55 56 57 58 59 60 61
62 63 64 65 66 67 68 69
70 71 72 73 74 75 76 77
78 79 80 81 82 83 84 85
86 87 88 89 90 91 92 93
94 95 96 97 98 99 100 101
102 103
To Next Page
Loading...
