FlashPoint R2 - Shoe Mount Flash Options

14
• SHOE MOUNT FLASH
The following options are
available when an optional
shoe-mounted ash unit is
attached and turned on.
1. Flash control mode: The ash control mode is selected from the ash unit. This can in
some cases be adjusted from the camera; the options available vary with the ash.
• TTL: TTL mode. Adjust ash compensation(2).
• MULTI: Repeating ash. Compatible shoe-mounted ash units will re multiple times
with each shot.
• (OFF): The ash does not re. Some ash units can be turned o from the camera.
2. Flash compensation/output: The options available vary with ash control mode .
• TTL: Adjust ash compensation (the full value may not be applied if the limits of the ash
control system are exceeded). In the cases of the Fujilm EF-X20, EF-20, and EF-42, the
selected value is added to the value selected with the ash unit.
• MULTI: Adjust ash output (compatible units only).
3. Flash mode (TTL): Choose a ash mode for TTL ash control. The options available vary
wilh the shooting mode (P, S, A, or M) selected.
• TTL AUTO (FLASH AUTO): The ash res only as required; ash level is adjusted
according to subject brightness. A icon displayed when the shutter button is pressed
halfway indicates that the ash will re when the photo is taken.
• Flash TTL (STANDARD): The ash res with every shot, if possible and the ash level
is adjusted according to subject brightness. The ash will not re if not fully recycled
when the shutter is released.
• TTL SLOW (SLOW SYNC.): This mode combines the ash with slow shutter speeds
when photographing portrait subjects against a backdrop of night scenery. The ash will
not re if not fully recycled when the shutter is released.