FlashPoint R2 - Multi Mode (C. FN-04-On)

19
Function
(under normal status) Enter CH settings;
(under settings) Confirm and back to normal status
Control the ON/OFF of modeling flash
Enter C.Fn custom settings
Switch the Operation Methods (Method 1/Method 2)
(under PTH status) Set power/times /hz
(under normal)Control the < Group>'s ON/OFF
(under PTH status) Back to normal status
Enter PTH status (P-power, T-times, and H-hz)
Function
No (3 groups)/Turning(5 groups)
Adjust the channel amount
Adjust the power amount
Adjust the times amount
Adjust the frequency amount
Operation
Short press
Double-click
Long press for 2 seconds
Long press for 5 seconds
Short press
Short press
Long press for 2 seconds
Status
Normal
Set the channel
Set the power
Set the flash times
Set the flash frequency
Multi Mode (C.FN-04-on)
Button
CH/OK
GR
MODE
Select Dial
OK