FlashPoint R2 - Operation Method Selection; Operation Method 1 (Default)

16
Selecting the Operation Method Options
Press the <CH/OK> Button for 5 seconds to switch the operation methods
(Method 1/Method 2).
R2T-F Operation Method 1 (by default)
Function
(under normal status) Enter CH settings;
(under settings)Confirm and back to normal status
Control the ON/OFF of modeling flash
Enter C.Fn custom settings
Switch the Operation Methods (Method 1/Method 2)
Select the group downwardly
Select the group upwardly
Select all the group
Switch the flash mode of the group (TTL/M/OFF)
Function
No (3 groups)/Turning(5 groups)
Adjust the channel amount
Adjust the group's POWER/FEC amount
Operation
Short press
Double-click
Long press for 2 seconds
Long press for 5 seconds
Short press
Double-click
Long press for 2 seconds
Short press
Status
Normal
Set the channel
Set the group
TTL/M Mode
Button
CH/
GR
MODE
Select Dial
OK