FlashPoint R2 - Operation Method 2

18
Function
(under normal status) Enter CH settings;
(under settings) Confirm and back to normal status
Control the ON/OFF of modeling flash
Enter C.Fn custom settings
Switch the Operation Methods (Method 1/Method 2)
Set POWER/FEC amount
Select all the group
(under normal status) Switch the < Group>mode
(TTL/M/OFF)
Function
Set < Group>
Set the channel amount
Adjust the group’s POWER/FEC amount
Operation
Short press
Double-click
Long press for 2 seconds
Long press for 5 seconds
Short press
Long press for 2 seconds
Short press
Status
Normal
Set the channel
Set the group
TTL/M Mode
Button
CH/
GR
MODE
Select Dial
R2T-F Operation Method 2
OK