SECTION 2 - OPERATION
page 2-13
DISCONNECTING IN TRANSPORT POSITION
The air drill may be disconnected in the transport position. To avoid damage to the machine and to avoid movement after
disconnection, it is recommended that the machine ALWAYS
be disconnected with the depth control locked in the ‘up’
position, with the floating hitch safety lock in place and the wheels blocked to prevent movement during disconnection.
1. Activate the depth control hydraulic circuit to raise the
implement to maximum height.
2. Engage the depth control safety lock.
3. Engage the floating hitch safety lock.
4. Activate the wing lift circuit and raise the implement
to full transport position.
5. Block the wheels to prevent movement.
6. Rotate the jack down from its storage position and pin
it in a vertical position.
7. Extend the jack to remove the weight from the tractor
or air seeder.
8. Disconnect the hydraulic hoses.
9. Unhook the safety chain and unplug the lighting cable
harness (if equipped).
10. If the air drill is equipped with a tow behind air
seeder, disconnect the cable harness from the tractor.
Disconnect the air seeder hydraulic hoses from the
tractor.
11. Remove the draw pin and carefully drive away.
To Next Page
Loading...