Flip-Pal 100C - Using Scans; Flip-Pal Software 2 on the SD Card; Windows and Mac Users

13
NOTE: The following information for Windows and Mac users assumes that you
have the latest version of the Flip-Pal
®
Software 2 on your SD card. Please go to
www.flip-pal.com for more details, which can be found on the Downloads tab in
the Support page.
4 Using Scans
The Flip-Pal
®
mobile scanner stores scans on the SD memory card the same way your digital
camera does. When you are ready to use your scans, simply transfer them to your computer
and use them just like any digital photo or image – crop, rotate, adjust color, print, etc.
To remove the SD card from the scanner, push it in gently. It will then spring out slightly,
allowing you to slide it out. It is recommended that you power off the scanner
before removing the SD card. If you remove the SD card while the scanner is on, you will
get a warning message “Insert Card/Power On”, then the scanner will turn off after 5-10
seconds.
When you are done using your scans on your computer, you can return the SD card to the
scanner.
NOTE: Please refer to your computer’s documentation for the recommended way to safely
eject and remove the SD card from your computer’s SD slot. Failure to do so could result in
the loss of your scans.
Flip-Pal
®
Software 2 on the SD Card
Windows and Mac Users
Flip-Pal
®
Toolbox 2 provides a variety of tools for transferring and using scans, as well as
getting help. Flip-Pal
®
Toolbox 2 runs directly from the SD memory card. You do not need to
install it on your computer. It enables you to:
• View or print the Flip-Pal
®
documentation
• Stitch scans together to reconstruct larger originals with Flip-Pal
®
EasyStitch
• Easily transfer scans to your computer for use and backup
• Upload images to share on the web on your Facebook, Picasa or other accounts
• Connect with the Flip-Pal
®
community
• Delete scans from the SD memory card
• (Windows only) Restore color (hue, contrast, etc.) on old photos
• Access www.flip-pal.com and customer support
To launch the Flip-Pal
®
Toolbox 2, power off the scanner, remove the SD memory card from
the scanner and insert it in your computer’s SD card slot. (If your computer does not have an
SD card slot, insert the SD memory card into the supplied SD memory card to USB adaptor,
then insert the adaptor into a USB slot on your computer.)
After you insert the SD memory card into your computer, find the Flip-Pal
®
SD card icon and
open it, then open the Win Flip-Pal
®
Toolbox 2 program or the Mac Flip-Pal
®
Toolbox
2 application depending on the kind of computer you have.