FLIR ETS320 - Display and Palette Adjustments

Operation
9
9.7 Measuring the coldest temperature within
an area
9.7.1 General
You can measure the coldest temperature within an area. This displays a moving spot-
meter that indicates the coldest temperature.
9.7.2 Procedure
Follow this procedure:
1. Push the center of the navigation pad. This displays a toolbar.
2. On the toolbar, select Measurement
. This displays a toolbar.
3. On the toolbar, select Cold spot
.
9.8 Hiding measurement tools
9.8.1 Procedure
Follow this procedure:
1. Push the center of the navigation pad. This displays a toolbar.
2. On the toolbar, select Measurement
. This displays a toolbar.
3. On the toolbar, select No measurements
.
9.9 Changing the color palette
9.9.1 General
You can change the color palette that the camera uses to display different temperatures. A
different palette can make it easier to analyze an image.
9.9.2 Procedure
Follow this procedure:
1. Push the center of the navigation pad. This displays a toolbar.
2. On the toolbar, select Color
. This displays a toolbar.
3. On the toolbar, select a new color palette.
9.10 Working with color alarms
9.10.1 General
By using color alarms (isotherms), anomalies can easily be discovered in an infrared im-
age. The isotherm command applies a contrasting color to all pixels with a temperature
above or below the specified temperature level.
9.10.2 Image examples
This table explains the different color alarms (isotherms).
#T810252; r. AA/41997/41997; en-US
20
1.888.475.5235info@FLIR-Direct.com
FLIR-DIRECT.com