427-0089-00-12 Version 160 March 2019 44
This document does not contain any export-controlled information.
Advanced Configuration
3.1.2 Video Setup
Video: By default, two video streams are enabled for the camera: Video 0 and Video 1. Both video
streams are available for viewing from a client program such as FLIR Latitude, a stand-alone video
player, or a third-party VMS (including ONVIF systems).
By default, Video 0 uses MJPEG encoding and Video 1 uses H.264 encoding. To modify parameters
that affect a particular IP Video stream from the camera, select the appropriate link (for example,
Video - 0).
With the factory configuration, the default parameters provide high-quality full frame-rate video
streams with reasonable bandwidth usage. In general, for most installations it will not be necessary
to modify the default parameters. However in some cases, such as when a video stream is sent over
a wireless network, it may be useful to “tune” the video stream to try to reduce the bandwidth
requirements. In particular, the RTSP Settings, Network Options, and the Settings parameters are
described below.
After making adjustments, scroll down to save the changes through power cycles.
Select analog
video format
To Next Page
Loading...
Need help?
General
